ELECTRICAL COMPONENTS. 08/10/15-01/11/2016. Headlamp range control.. 2021 Audi A5

Front sensor mount bolt. Left.HEADLAMP RANGE CONTROL. Right.HEADLAMP RANGE CONTROL. A screw that is used to secure the Steering Gear Dust Shield to it's mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc) on one end used to secure the Engine Mount Heat Shield to it's mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc) on one end used to secure the Floor Pan Splash Shield to it's mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the CV Joint Splash Shield to it's mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Fender Reinforcement to it's mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Floor Pan Crossmember to it's mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Fuse & Relay Center to a mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Steering Gear Shield to its mounting surface. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Turbocharger Heat Shield to a mounting point. Engine Coolant Reservoir Bolt. Hardware to attach the Heat Shield to the catalytic converter. Headlight Level Sensor Bolt. Power Steering Pressure Line Bolt. Trunk Trim Panel Bolt. Included with: Housing.

Front sensor nut. Left.HEADLAMP RANGE CONTROL. Right.HEADLAMP RANGE CONTROL. A Nut used to secure the fuel pressure regulator to it's mounting point. A solid metal or plastic block with a threaded hole in the center which is used to secure the Hood Safety Catch to it's mounting point. A solid metal or plastic block with a threaded hole in the center which is used to secure the Seat Air Bag Inflator Module to its mounting point. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Brake Cooling Duct. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Cruise Control Distance Sensor. Bolt that secures the Hood Latch. Engine Cooling Fan Blade Nut. Headlight Level Sensor Nut. Hood Latch Striker Plate Nut. Part cannot be reused/reinstalled. Suspension Strut Nut. Tail Light Nut. Trim panel for the Convertible Top Stowage Compartment. Included with: Pressure regulator.

Left.HEADLAMP RANGE CONTROL. Rear sensor nut. Right.HEADLAMP RANGE CONTROL. A Nut that attaches the Axle Beam to the sub-frame. A rubber ring with a hole in the center which provides protection through which Suspension Control Arm related components pass through. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Active Suspension System Height Sensor. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Door Reinforcement Bar. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Door Shell. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Tail Lamp Pocket. Headlight Level Sensor Bolt. Headlight Level Sensor Nut. Part cannot be reused/reinstalled. Suspension Control Arm Nut. Included with: Capacitor.